Safety Rooftop Railings for Embassy Compound

SCOPE OF WORK SHEM and OSHA require guard rails on roof tops where work is performed in areas with a fall risk. Guard rails shall be put into place along the roof edge near any equipment within 10 feet of the roof edge without a parapet at least 4’ high. No roof penetrations will be used, and nothing attached to the building structure. Scope only includes the procurement of the required safety equipment on the roofs.

The railing system installed will be a modular design and be able to easily raise and lower the railings without tools or special knowledge. The finish is to be corrosion resistant, such as stainless steel, galvanized, or exterior grade powder coat. Railing are to use weighted feet/anchors, no roof penetrations required.

Guardrail systems shall be capable of withstanding, without failure, a force of at least 200 pounds (890 N) applied within 2 inches (5.1 cm) of the top edge, in any outward or downward direction, at any point along the top edge. Rails Must meet all international health, safety, environmental (HSE) standards and HSG-33, and meet OSHA 1926.501(B)(1) guidelines.

Acceptable guard rail systems include (FAR 52.211-6 Brand Name or Equal): https://keesystems.com/service/collapsible-rooftop-guardrail https://www.tiedown.com/shop/safety/guardrail-systems/guardrail-kits/5-collapsible-guardrail-kit-ts22-safety-yellow https://www.heightsafesystems.com/products/guardrail-systems/collapsible-folding-guardrail https://www.source4industries.com/products/kee-non-penetrating-rooftop-guard-railing-long-kit-osha-certified?variant=43734461481185&campaignid=21678224096&adgroupid=&creative=&matchtype=&network=x&device=c&keyword=&gad_source=1&gclid=CjwKCAiAt4C-BhBcEiwA8Kp0CZ76vYFLbSK8uq06dy9l9Xmb_BHpy-_p-FLL1LJzSGhVX09mIT_IjRoCx3gQAvD_BwE https://simplifiedsafety.com/safety-railing/roof-safety-railing/?keyword=rooftop%20guardrails&creative=501311574919&gad_source=1&gclid=Cj0KCQjw9Km3BhDjARIsAGUb4nx8_uWGFG4O7czTbVua0IQ7j9gDqkmbyWDfHAIIIQZXg4EXfQa-dbQaAsq6EALw_wcB Final selection will be made based on FAR requirements. Buildings included are FAC Shops, MCAC, SCAC, CCAC, Utility, Warehouse, Chancery.

Note: Collapsible guard rails for rooftop fall protection must be a modular design and be able to easily raise and lower the railings without tools or special knowledge. The finish is to be corrosion resistant, such as stainless steel, galvanized, or exterior grade powder coat. Railing are to use weighted feet/anchors, no roof penetrations required. Must meet all OSHA, all international health, safety, environmental (HSE) standards and HSG-33.

All quotations shall be submitted by electronic mail to TashkentProcurement@state.gov with the subject 19UZ8025Q0018 not later than 12:00 pm Tashkent time (GMT+5) on May 4, 2025. Quotations submitted after 12:00 pm Tashkent time (GMT+5) on May 4, 2025 will not be accepted. Please indicate on e?mail subject the RFQ reference i.e. “RFQ/ 19UZ8025Q0018”. Applicants with questions regarding this bidding should send in writing to:

?-mail:

TashkentProcurement@state.gov Attn: Procurement Department In order for a quotation to be considered, you must also complete and submit the following:

1. SF-18 2. Section II, Pricing 3. Proof of SAM Registration Prepayment is not authorized. Offerors shall be registered in the SAM (System for Award Management) database at https://www.sam.gov prior to submittal of their offer/proposal as prescribed under FAR 4.1102. Failure to be registered at time of proposal submission may deem the offeror’s proposal to be considered non-responsible and no further consideration will be given. Therefore, offerors are highly encouraged to register immediately if they are interested in submitting a response to this requirement.