Solder

SLAC National Accelerator Laboratory is operated by Stanford University for the Department of Energy. As a management and operating contractor, subcontracts awarded by the Laboratory are not Federal procurements, and are not directly subject to the Federal Acquisition Regulations in 48 CFR. Nonetheless, certain Federal laws, Executive Orders, and regulations may affect our DOE approved purchasing system, as required by statute, regulation, or contract terms and conditions.

AMENDMENT 01: AMENDMENT 01 HI, The following Addendum is being issued for the subject Request for Quotation: 346380 Technical criteria updated to:

3: RTD needs to be Ultra High Vacuum compatible by being able to operate in the 10^-7 Torr or better regime and be able to go through and pass vacuum processing (i.e. bakeout and RGA). RTDs will be used in LCLS Level 3 Vacuum assemblies. #6: RTD base dimensions (not including length of wire) are preferred to be within an 8.9 mm x 7.6 mm envelope. RTD base dimensions greater than a 12.7 mm x 14 mm envelope are not acceptable. RTD thickness shall be less than 6 mm. The bid close date is extended to:

December 4, 2024. This Addendum modifies the Request for Quotation and must be acknowledged. Failure to acknowledge all addenda could make your proposal non-responsive. Please confirm that the submitted proposal is not changed because of this addendum. If proposal sent is revised because of this, please submit the revised proposal. The following changes are hereby made to the appropriate documents contained the above-mentioned Request for Quotation (RFQ). All other terms and conditions of the RFQ remain the same. Thank you very much. Katherine Jill A. Coh SCM Commodities Team Lead SLAC National Accelerator Laboratory 2575 Sand Hill Road Menlo Park, CA 94025 Tel:

650-926-2770 Email: kcoh@slac.stanford.edu