AFTO 350 REPAIRABLE ITEM PROCESSING TAG

PRODUCT: This specification is for proofing, printing, numbering, corner cutting, drilling, packing, and shipping of tags TITLE:

AFTO 350 REPAIRABLE ITEM PROCESSING TAG QUALITY LEVEL: III Quality Assurance Through Attributes (GPO Publication 310.1, effective May 1979 (Rev. 09-19)) applies. QUANTITY:

3,000,002 TRIM SIZE: 3-1/4 x 7-1/2" DESCRIPTION:

PRINTING: Tag prints face and back in black ink, consisting of text and lines. Printed tags must provide clean, dense, and legible type matter. An approximate 5/16 x 15/16 screened area will print at the bottom of back side of tag; screened area is to remain open and not fill in. Print head-to-head.

CONSTRUCTION: Drill/punch one round hole; 1/4" in diameter, centered on the top 3-1/4" Dimension, center of hole 3/16" from top of tag. Reinforce both sides of tag with a hard fiber patch. No metal eyelet or stringing required.

Corner Cut: Clip both corners with diagonal cuts at the top left and right (patch end).

NUMBERING: Number each tag on the face side in two (2) places (same 6-digit number in each place), parallel to the 3-1/4" way, in the TAG NO. areas. Number from 0000003 through and including 3000002 & use 0000001-0000002 For Samples only – (See Distribution) repeating the sequence until the entire quantity is accomplished. DO NOT INCLUDE ANY NUMBERS THAT END IN 000 (three zeroes). Numbers to be 3/16 -l/4" high.

The number at the bottom of the tag must be placed one-sixth (l/6") from bottom edge of tag to ensure visibility in file utilized; the corresponding number should also be placed l/6" up from the perforation. Numbering is to be in black ink. There are to be no missing numbers other than the ending 000 numbers.

PERFORATION: Perforate each tag the full 3-1/4'' way) approximately 2" from bottom. The perforation is to align with the rule just above the text for item 16. SUPPLY DOCUMENT NUMBER on face side of tag and just above the text for item 29 on the back side of tag.